This system allows for repeatable parallel cuts without manually measuring and marking each piece.

: Crucial for accuracy. Align the stops with a pencil mark on a fresh splinter guard cut. Use a flathead screwdriver to fine-tune the bracket position if the measurement doesn't match the scale. 3. Operational Best Practices

Selecting the correct length is critical to ensure the saw is fully supported during the entire cut.

: When using an MFT/3 Multi-Function Table, ensure the guide rail is long enough to clear the board at both the start and end of the cut to prevent kickback. 4. Alternatives & Enhancements Festool Parallel Guides

: If you must connect two rails, use Guide Rail Connectors. While functional for long rips, a single long rail is always more accurate.

Insert the tab into the middle groove and tighten the green knobs. Adjust the stop to your desired measurement.

: Ideal for cross-cutting 4-foot or 5-foot (5x5) sheets with extra "run-in" and "run-out" space.

: Always start with a clean "reference edge" by trimming the factory edge of your plywood before making parallel cuts.